Paasche-airbrush D500 Manual de usuario

Busca en linea o descarga Manual de usuario para Accesorios para el aire Paasche-airbrush D500. Paasche Airbrush D500 User Manual Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 1
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
INSTRUCTION AND PARTS LIST D500 & D500SR, 8/31/2011
Supercedes Instruction & Parts List D500, 8/28/2008
WARNING: When a flammable liquid is sprayed, there may be
danger of fire or explosion especially in a closed room: keep
compressor at least 20 feet away from areas where hazardous
concentrations of flammable vapors are likely to occur.
Disconnect power before servicing.
ATTENTION: Lorsqu'un liquide inflammable est pulverise, il
peut y avoir danger d'incendie ou d'explosion, specialement
dans une piece fermee; garder le compresseur a au moins 20
pieds des endroits ou des concentrations dangereuses de
vapeurs inflammables sont susceptibles de se produire.
Debrancher avant toute maintenance.
Manufactured in China for Paasche
Paasche Airbrush Company
4311 North Normandy Avenue, Chicago, IL 60634-1395
Phone: 773-867-9191 Fax: 773-867-9198
Website: paascheairbrush.com • E-Mail: info@paascheairbrush.com
D500 & D500SR Air Compressor
1/8 HP, 110-120Volts, 60Hz, .25 CFM @ 30 P.S.I.,
Shipping Weight: 4kgs (9 lbs.). Delivers 20-40
PSI depending on Airbrush being used.
ETL Listed.
The D500 Air Compressor is suitable for all airbrushes spraying
properly thinned fluids. This is the most economical Air
Compressor Paasche offers to the art, hobby and craft fields. It
is an oil-less piston unit that comes with 6 foot cord. The D500 is
1/8 H.P. and operates on 110-120 Volts, 1 Phase, 60 Cycle, and
delivers .25 C.F.M. at 30 P.S.I. Several working pressures are
available. The compressor will shut down and restart when the
pressure reaches the set pressure. The hose connection is 1/4''
NPT and can be used with the R-75 Air Regulator for greater
control of pressure to the Airbrush.
INSTRUCTIONS:
BEFORE OPERATING COMPRESSOR, READ AND FOLLOW
DIRECTIONS AS OUTLINED BELOW.
1. Set Compressor on floor. Compressor vibrates and may
“walk” off elevated surfaces, possibly causing damage to unit
or injury to you.
2. Plug cord into 115 Volt, 60 Cy., grounded outlet.
GROUNDING INSTRUCTIONS:
This product should be grounded. In the event of an electrical short
circuit, grounding reduces the risk of electrical shock by providing an
escape wire for the electric current. This product is equipped with a
cord having a grounding wire with an appropriate grounding plug. The
plug must be plugged into an outlet that is properly installed and
grounded in accordance with all local codes and ordinances.
DANGER—Improper use of the grounding plug can result in a
risk of electrical shock.If repair or replacement of the cord or
plug is necessary, do not connect the grounding wire to either flat
blade terminal. The wire with insulation having an outer surface
that is green with or without yellow stripes is the grounding wire.
Check with a qualified electrician or serviceman if the grounding
instructions are not completely understood, or if in doubt as to
whether the product is properly grounded. DO NOT modify the
plug provided; if it will not fit the outlet, have the proper outlet
installed by a qualified electrician.
This product is for use on nominal 120-volt circuit and has a
grounding plug that looks like the plug illustrated in sketch below.
Make sure that the product is connected to an outlet having the
same configuration as the plug. No adapter should be used with
this product.
EXTENSION CORDS:
Use only a 3-wire extension cord that has a 3-blade grounding plug,
and a 3-slot receptacle that will accept the plug on the product.
Make sure your extension cord is in good condition. When using an
extension cord, be sure to use one heavy enough to carry the
current the product will draw. An undersized cord will cause a drop
in line voltage resulting in loss of power and overheating.
AUTOMATIC THERMAL LIMITED
The D500 will shut off automatically when overheated. to restart,
release air pressure and let D500 cool down. Automatic reset.
GROUNDING METHOD
Grounded Outlet
Cover of
grounded
Outlet Box
Grounding Pin
D500SR Air Compressor, 110-120Volts, 60Hz.
with R-75 Air Regulator & Gauge
(
Gauge shown face forward - actual assembly face up)
D500 Air Compressor, 110-120Volts, 60Hz.
Gauge
Vista de pagina 0
1

Indice de contenidos

Pagina 1 - Grounding Pin

INSTRUCTION AND PARTS LIST D500 & D500SR, 8/31/2011Supercedes Instruction & Parts List D500, 8/28/2008WARNING: When a flammable liquid is spra

Modelos relacionados D500SR-PL

Comentarios a estos manuales

Sin comentarios